<< Go back to Main Site
Part 91.411/91.413 Recertification Intervals

Part 91.411/91.413 Recertification Intervals

The aviation industry has many requirements and certifications. In this blog, we would learn the about the two inspections that aids in planning for the maintenance and the correct equipment use to service an equipment.

Recertification Periods

Both Part 91.411 and Part 91.413 have a period of 24 calendar months. The Part 91.411 applies to the static pressure, altimeter and automatic altitude reporting system. While, the Part 91.413 states that all transponders must be inspected up to 24 calendar months. This requirements applies to flights using IFR, but also those that are not IFR. So if it was inspected in March 2026 then it will be valid until 31 March 2028. For each part, the date is the date of inspection not the flight.

Inspection Details

  • Part 91.411 - Static Pressure Systems, Altimeters and Altitude Reporting

According to the Part 43 Appendix E, tests carried out under the following regulation is for humidity, leaks and blockages, scale error, and hysteresis. Note that the scale error tolerance depends upon the altitude but the altimeter should be within 125ft.

  • Part 91.413 ATC Transponder Check

As for Part 91.413, a personnel tests the transponder response frequency, suppression, RF peak power output, and receiver sensitivity. Note that these are requirements for the Mode S.

Types of Equipment Used for Part 91.411/91.413 Recertification Intervals

  • Pitot Static Testers / Air Data Test Sets

The ADTS equipment test the static pressure system and the altimeter. These equipment checks the range of the pressure is appropriate, and that they have the appropriate hoses and adaptors for the aircraft. In addition, make sure that this equipment are correctly calibrated and properly maintained before testing. If you're looking for these type of requirement, AvionTEq offers pitot static testers and air data test sets available to buy or rent.

  • Transponder Test Sets

The transponder test sets is used to do interrogation and measurement. These test sets perform radio rating, and diagnostic of an aircraft's transponder and surveillance systems. If you're looking for these type of test sets, AvionTEq has a number of transponder test sets like VIAVI/Aeroflex IFR6000 to purchase or rent, it has a large list of configurations and accessories to suit your aircraft needs. Note that any test equipment used at your repair station will need to be calibrated according to 145.109.

Additional Inspections

Some maintenance may require additional inspection. If the static system is closed (unless drains or other valves are present on the system) then the system must be fully inspected. Any work which could cause an altitude error should be followed by a full inspection of the system.

Who Can Carry Out the Inspection?

It is based on the ratings of the service provider and inspection. The ratings of the aircraft manufacturer and repair station can be used to perform Part 91.411. The airframe technician of the aircraft must only have the rating to perform static pressure system. The ratings of the aircraft manufacturer, the holder of the maintenance programme, and the repair station are used to perform the Part 91.413.

FAA Rules for Non US Registered Aircraft in the UK

It works even when the aircraft isn't in the US. This is standard Part 91, no matter where the aircraft is operating, even if it is outside the US. It's the same as any out-of-country operation – just follow the rules of the destination country. Make sure your handling agent is capable of performing the work.

Recertification Planning

If you're looking for a company that can perform this type of recertification for your equipment, AvionTEq can provide you a quote. Request a quick recertification quote today.

Share   

Add comment